奧德機電制造有限公司

聯系人：胡先生  

QQ:1455638869

聯系電話：15262628669  

公司網站：http://www.aodejix.com
工廠地址：深圳，蘇州，天津國內三家制造基地。
高光模溫機的性能介紹:

傳統注塑模具溫度控制的不足之處如下
Disadvantages of the traditional temperature control technology for injection molds:
無法滿足高光注塑中快速升溫及快速降溫的需要。
The need of high-gloss injection molding for quick temperature rising and drop cannot be met.
升溫幅度較小，制品表面的溶接痕只能得到減輕而無法消除。
The margin of temperature rising is very small. As a result, the welding traces on product surfaces can be alleviated rather than removed thoroughly.
由于塑料硬度越高，流動性越差。因此采用此種工藝，制品表面的硬度只能達到HB級，無法滿足實際使用需要。
Due to the great hardness and poor fluidity of plastics, this technology can only make the surface hardness of a product grade HB, failing to meet the actual requirements of application.
模具升溫時受熱膨脹，降溫時又會收縮，使鎖模力很不穩定。
Due to the mold’s expansion when in temperature rising and its shrinkage when in temperature drop, the clamping force is quite unstable.
容易造成制品打不滿，燒焦、內應力大等各種缺陷。
Thus, the products are easy to suffer from short molding, scorching, excessive internal stress and other defects.
 
模具的配置
Configuration of die
模具內表面要求非常高的光潔度，以確保制品的表面質量。
The mold’s inner surface should be very smooth, so as to ensure high surface quality for products.
模具內部開設管道必須合理，以確?？梢钥焖偕郎睾徒禍?。
The pipelines arranged in the mold must be rational so that temperature can rise or drop quickly.
模具內部的管道應該導熱性能良好。
The mold’s internal pipelines should be of good heat conductivility.
由于生產過程中需要不停加溫及降溫，模具選用的鋼材要好。
The necessity to have temperature rise and drop frequently in production makes it necessary to select good steel materials for the mold.
組織結構均勻，熱脹冷縮系數小。
The organizational structure is even and the expansion and shrinkage coefficients are small.
在使用過程中要尤其注重模具的保養，確保干燥、無塵。
Pay special attention to the mold’s maintenance when in use, making it dry and dustless.